The First Ever Pressure Detonator Ever!
by the mechanical engineer in Outside > Launchers
382 Views, 6 Favorites, 0 Comments
The First Ever Pressure Detonator Ever!
this is pretty cool, the first ever pressure detonator on this site. its really cool. basicly u step on it and it EXPLODES!!! designed to be used with my airsoft landmine
Obtian Materials
the stuffs you will need will be as follows:
wire
6 or 9 volt battery
cardboard
electrical tape
paper clips
wire
6 or 9 volt battery
cardboard
electrical tape
paper clips
Make the Pressure Circut Compleater: Part One
make the push part:
attach one end of one of the wires to a paper clip with electrical tape and then insert a small strip of cardboard into the paperclip.
it really helps if these paperclips are big.
attach one end of one of the wires to a paper clip with electrical tape and then insert a small strip of cardboard into the paperclip.
it really helps if these paperclips are big.
Make the Pressure Circut Compleater Part 2:
make the pressure compleater base.
attach a paperclip to the end of the second wire and then tape it sideways to the cardboard, under the item compleated in part one, which was also taped to the cardboard base layer. the two paperclips, when placed together, should be perpendicular, or at 90 degree angles.
attach a paperclip to the end of the second wire and then tape it sideways to the cardboard, under the item compleated in part one, which was also taped to the cardboard base layer. the two paperclips, when placed together, should be perpendicular, or at 90 degree angles.
Add the Weak Supports
the next step is to take two weak paperclips and stick them on the sides so that they will hold up the top part but will easily bend when steped on. srry no pic
Split the Wire to Add the Clips
next is split one wire leading to the circut and add aligator clips. note that i used paperclips not aligator clips cuz they were on my remote detonater.
Connect to Battery and Set.
uhhhhh. kinda self explanatory. connect it to the battery.