Remote Control F-117A Stealth Bomber

I made this f-117A stealth bomber because I wanted a cool looking jet glider and I had some extra electronics laying around so I threw this together and i have had lots of fun with it. I made it with dollar tree foam, packing tape and hot glue.

specs.

• wing span:44"
  
• length:46"
• high:8"
• the longest flight was about 150' just throwing it

step.

1. first you need to glue and tape the three peaces of dollar tree foam together
2. next you need to draw a line down the center
3. then you need to measure 14 inches down from the top
4. from the 14 inch mark you need to draw a line down to the far corners
5. then draw a line five inches from the bottom of the boards that is parallel to the bottom that is 10 inches long
6. then take a ruler and make two lines from the edges of the 10 inch line and draw a inch up
   
7. connect the corner of the wings to the top of the inch marks
8. from the center of the 10 inch line draw a line one inch down
9. connect the sides of the line to the new inch mark

1. cut out your airplane
2. take the scraps from under the wings and cut it in half

1. take the peaces and cut and place so they fit nicely glue that down