----------------------------------------------------------------------------------
Networking on WRT160NL

for Wifi to function need to flash OpenWRT 10.03.1 , for example rc4.

iwlist scanning
Scans networks. I receive TRENDnet on ch1



I tried to make a bridge that receives free WLAN internet from neighbours and makes own network in the apartment. 

It is possible to build this bridge in Luci interface under administration/newtork. No need to 
do the code below. I just leave it for reference. Not sure it works.



http://wiki.openwrt.org/doc/howto/clientmode#bridged.client.mode.brcm-2.4.only

/etc/config/wireless
 config wifi-iface
 option mode         "sta"   before was ap


http://martybugs.net/wireless/openwrt/client.cgi

wlanconfig

http://wiki.openwrt.org/doc/howto/wireless.repeater

brctl show


-----------------------------------


# wireless
config 'wifi-device' 'radio0'
        option 'type' 'mac80211'
        option 'channel' '11'
        option 'macaddr' 'c0:c1:c0:43:8f:a6'
        option 'hwmode' '11ng'
        option 'htmode' 'HT20'
        list 'ht_capab' 'SHORT-GI-40'
        list 'ht_capab' 'DSSS_CCK-40'
        option 'disabled' '0'

config 'wifi-iface'
        option 'device' 'radio0'
        option 'network' 'lan'
        option 'mode' 'ap'
        option 'ssid' 'OpenWrt'
        option 'encryption' 'none'
#=========================================

# network


config 'interface' 'loopback'
        option 'ifname' 'lo'
        option 'proto' 'static'
        option 'ipaddr' '127.0.0.1'
        option 'netmask' '255.0.0.0'

config 'interface' 'lan'
        option 'ifname' 'eth0'
        option 'type' 'bridge'
        option 'proto' 'static'
        option 'netmask' '255.255.255.0'
        option 'ipaddr' '192.168.1.1'

config 'interface' 'wan'
        option 'ifname' 'eth1'
        option 'proto' 'dhcp'

config 'switch'
        option 'name' 'eth0'
        option 'reset' '1'
        option 'enable_vlan' '1'

config 'switch_vlan'
        option 'device' 'eth0'
        option 'vlan' '1'
        option 'ports' '0 1 2 3 4 5'









==================================================================
Tried aircrack. Could not get it working . Probably WLAN chip not supported.

http://www.hackinfo.nl/wep-hacking/78-cracking-a-wep-using-openwrt-on-your-wrt54g-router.html
opkg list_installed
opkg update
opkg install aircrack-ng
okpg install kismet-server
opkg install kismet-client

wl monitor 1
ifup prism0
airodump-ng --ivs --write wep out 7 prism0