Part 1; Beginner Rc Airplane (body)

by robobot3112 in Circuits > Remote Control

1985 Views, 14 Favorites, 0 Comments

Part 1; Beginner Rc Airplane (body)

IMG_0017.JPG

hi there.

here is an economical and simple airplane body.

it took me just 15 minutes to set up the body.

this is rather small. approx 14 inches long.

stay tuned for the next part (electronics).

What You Need.

IMG_0001.JPG

foamboard. 6mm depron or dollartree might work, i did not have either.

tape (electrical tape, not shown in pic)

scale (not shown)

patience

scissors

Get Crankin'

IMG_0002.JPG
IMG_0003.JPG
IMG_0004.JPG
IMG_0005.JPG
IMG_0006.JPG

cut a 12" or 14" (all units inches) long by 12 centimeter (only take cm if i specified it).

divide it into three 4 cm divisions.

make a cut (donot cut through the paper)

hot glue them together.

Wing (armin Wing)

IMG_0007.JPG
IMG_0010.JPG
IMG_0009.JPG
IMG_0011.JPG

cut a 14" by 10" piece.

bend it across the 10" side to get a 14" by 5" wing.

hot glue them together.

refer to the picture for further clarity.

you should be getting a nicely curved wing

The Attaching

IMG_0012.JPG
IMG_0013.JPG

this step requires extreme caution. I talk from experience of hot glued hands. It was a sticky encounter.

hot glue the wing to the fuselage.

i have not mentioned where to hot glue the wing because the cg (center of gravity) can be adjusted later on when electronics are attached.

Horizontal and Vertical Stabilizers

IMG_0014.JPG

start with a 5.5" piece of foam board . leave a 1cm gap on either side and make hinges using electric tape then

take 3 cm from the top and cut to the center.

for the rudder, cut a 4" piece of foam. make a diagonal cut from one end to the other

/----------------------/

/ l

/ /

/--------------------/

sorry for the shake (weird symbolistic rudder) but looks kind of like that. follow the lines.

again sorry.

Cover the Rest of the Fuselage

IMG_0015.JPG

cover the rest of the fuselage with foam and hot glue them.

Make Hinges

IMG_0016.JPG

make hinges using tape for the rudder and elevator

Finished

IMG_0017.JPG

the body of our small plane is finished .

i will publish a part 2 with the electronics to make it a real rc aircraft. (model)