Knex Remote Controlled Thing
RC your knex.
The Parts
electronics:
knex motor
old rc car reciever and matching remote
power
Rods:
2 orange or red
2 yellow
Spacers:
11 blue
1 grey
Connectors:
2 tan
2 white or black
6 purple or grey (only 4 in the pic)
Wheels:
4 small ones
knex motor
old rc car reciever and matching remote
power
Rods:
2 orange or red
2 yellow
Spacers:
11 blue
1 grey
Connectors:
2 tan
2 white or black
6 purple or grey (only 4 in the pic)
Wheels:
4 small ones
The Electronics
Connect the power to the reciever. Open the motor and make shure it takes 2 AA. Now put the red wire on the positive part by the switch. Put the black wire on the negative side. Tape those or put in dead batteries to hold them in place.
Make This
there are 2 spacers after the left wheel. There are 9 spacers in the middle.
Put the Modor On
put the modor inbetween the two white connectors. Put a yellow rod threw and add one tan connector on each side faceing outward. Slid the wheels on. Put the grey connectors on the end.
Drive Drive Drive!!!
Drive your RC.
Send Me Your Pics!!!!!
Send me your pics!!!! I want to see your instructables in action.