Knex Rubber Band Gun (RBG) MY ORIGINAL DESIGN
by EpicMinecrafter870 in Living > LEGO & K'NEX
856 Views, 1 Favorites, 0 Comments
Knex Rubber Band Gun (RBG) MY ORIGINAL DESIGN
Hey guys. Here is my simple to make knex rubber band gun. It is my first Insructable and I hope you like it. Here you go.
Pros-
shoots hard
small, good in a knex war
Cons-
Trigger not the best
no mag for multi-ammo holding
Pros-
shoots hard
small, good in a knex war
Cons-
Trigger not the best
no mag for multi-ammo holding
Handle
For this part, you will need the following
connectors-
1 purple or grey 3d half moon
1 blue 3d full circle
3 red 1/4
rods-
2 yellow
Make what you see in the pics and set it aside. don't worry about a trigger, that is on the barrel on this model. please don't criticize it, it's my first Instructable.
connectors-
1 purple or grey 3d half moon
1 blue 3d full circle
3 red 1/4
rods-
2 yellow
Make what you see in the pics and set it aside. don't worry about a trigger, that is on the barrel on this model. please don't criticize it, it's my first Instructable.
Barrel
You will need for this
Connectors
8 yellow halves
1 yellow orange half with nub on bottom (substitute for yellow if you don't have one. nub just for looks.)
2 white full circles
rods
1 tan, red, or yellow orange (they're usually the red ones, but they are all the same.)
1 white
1 yellow
Connectors
8 yellow halves
1 yellow orange half with nub on bottom (substitute for yellow if you don't have one. nub just for looks.)
2 white full circles
rods
1 tan, red, or yellow orange (they're usually the red ones, but they are all the same.)
1 white
1 yellow
Cocking Mech and Trigger
you will need
connectors
1 orange
1 green
rods
2 blue
build what is in the pics indicated by the boxes.
connectors
1 orange
1 green
rods
2 blue
build what is in the pics indicated by the boxes.
Rubber Bands
add rubber bands as shown in intro.
Firing
pull back mech until trigger falls into position. pull it to fire.