How to Make a Push Arm for the Table Saw
by alexg041282 in Workshop > Woodworking
2340 Views, 20 Favorites, 0 Comments
How to Make a Push Arm for the Table Saw

materials needed 10inX20in plywood, T square or level, a tape measure and a pen and a band saw
Mark Your Lines


I like starting in the corner a measure one inch at the bottom and at the top three inches then i make my lines. I then make a house shape at the top right i measure inch and a half on each side and one inch down and then one inch across.
Using the Band Saw



then i slowly cut at my marks
Using the Beltsander

now that you cut out your arm then you would take it to the belt sander and smooth out all edges
The Arm at Work


now go ahead and try it out