Hovercraft by Carmex=]
We Started by Cutting Our 4x8 Plywood in Half; Using Only One of the Halves.
We Cut Off Excess Corners and Made It Into a Circle.
We Sanded the Edges and Cut Out a Hole for Leaf Blower Using a Jigsaw
We Stapled the Tarp On, Then We Duct Taped Where We Thought Air Would Escape
We Cut Out _ Circle From Dry Erase Board and Drilled It Into the Middle of Our Hovercraft on the Tarp Covered Side. Instead of Using a Cariage Bolt, We Used (5) Sheet Metal Screws to Ensure Durability.=)
Exactly 9" Away From the Center, We Cut Out Holes in the Tarp. Evenly Spaced, We Drew Out 4 _ Inch Circles and Cut Them Out Using a Box Cutter.
Fianally We Tested It and Decided to Add 2 More Holes. (we Probably Should of Gone With 8 Holes All Together).
Fianally We Took That Baby for a Spin.
