Diy Shelf Division
Hi this is my first instructable.
Gather the Parts
Parts:
Old transformer (From junk)
Tools:
Lighter (1)
Hot glue stick. (1)
(you could use hot glue gun instead of lighter)
Old transformer (From junk)
Tools:
Lighter (1)
Hot glue stick. (1)
(you could use hot glue gun instead of lighter)
Pull Out the Plates
Take apart the transformer and save the plates.
Story I didn't took the photo of this process.
Story I didn't took the photo of this process.
Bend the Plates
Bend the plates as shown in the photo.
I used a heatsink for holding it in place.
I used a heatsink for holding it in place.
Mark the Positions and Place It
Place the glue as marked.
Stick it to the shelf.
I used 3 of them.
Stick it to the shelf.
I used 3 of them.
Finally
Place a cardboard or glass sheet tight on the plates.
if the board is loose the plate may come off.
Hope you enjoyed this instructable.
I am participating in the hot glue challenge.
Vote for me.
I will upload my next instructable soon.
if the board is loose the plate may come off.
Hope you enjoyed this instructable.
I am participating in the hot glue challenge.
Vote for me.
I will upload my next instructable soon.