Your First Electronic Pcb/project
by jwoo2023 in Circuits > LEDs
7410 Views, 10 Favorites, 0 Comments
Your First Electronic Pcb/project
Hehe... Your project is here.
A LED activator.
Simple...
A LED activator.
Simple...
Needs...
PCB(above)
LED(small)
510ohm resistor
3v flat button cell battery
Thin wire
LED(small)
510ohm resistor
3v flat button cell battery
Thin wire
In Goes the Pieces...
Print the pcb layout on to paper.
Push the LED in to the pcb where it's marked.(Flat/short side of led is -)
Push the resistor in.
Solder or glue the thin wire on to each side of the battery.
Push the + through the hole and - through the hole at the bottom.
connect the resistor(one side) to the led +.
connect the - of the led to the - of battery.
connect the + of the battery to the resistor(other side).
Done!
Push the LED in to the pcb where it's marked.(Flat/short side of led is -)
Push the resistor in.
Solder or glue the thin wire on to each side of the battery.
Push the + through the hole and - through the hole at the bottom.
connect the resistor(one side) to the led +.
connect the - of the led to the - of battery.
connect the + of the battery to the resistor(other side).
Done!
Light!
