"Y" SHAPED DOG TUG & TOSS TOY

These easy to make colorful rope toys are great for any size dog.

"Y" SHAPED DOG TUG & TOSS TOYProject Cost $1.68
(100' of rope at $7.00 = $0.07 a foot; Project 24' x $0.07 = $1.68)

Check out my basic version of this toy at Dog Toys for Heavy Chewers

If you are having trouble tying the knot see my video BASIC KNOT VIDEO

(If you are concerned with your dog ingesting the nylon rope, natural 3/8" jute rope can be used instead)

WARNING

Please discard if toy becomes damaged or torn. Not intended for children. Should be used for chewing & playing only. Supervision is recommended when dogs are playing with toys.

 

1. Materials & Tools Needed for “Y” Shaped Dog Tug & Toss Toy
•3/8” Rope
•Tape Measure
•Scissors
•3 Small Zip Ties
•Marker
•Needle-Nose Pliers or Hemostats
•Lighter

2. Cut six 48” lengths of rope, lightly melt ends of rope with lighter to prevent fraying
(1” finished project = approximately 4” of rope)

3. Take four of the 48” lengths of rope and fold in half, mark if needed with marker

4. Secure the four ropes with a small zip tie in the center (note: the zip tie will be removed later on in project)

5. From the zip tie split the four ropes into two groups of two

6. Take remaining two ropes divide in half, place center of ropes where you divided four ropes into two groups of two

7. Secure with zip tie on each side creating three groups of four ropes each when finished

8. Start with the first group of four ropes you created grasping at zip tie using a lightly closed fist with thumb extended

9. Spread the ropes out over the top of fist with one rope behind thumb

10. Take rope (rope 1) from behind thumb and wrap around it and over the next rope (rope 2)

11. Take second rope (rope 2) go over first rope (rope 1) and over next rope (rope 3) keeping first rope (rope 1) looped around thumb

12. Then take third rope (rope 3) go over second rope (rope 2) and over last rope (rope 4) again keeping first rope (rope 1) looped around thumb

13. Using last rope (rope 4) over third rope (rope 3) and thru loop of first rope (rope 1) that was looped around thumb

14. Tighten up each length of rope

15. Continue tightening ropes until a uniformly tight knot is created

16. Repeat steps 9 thru 15

9. Spread the ropes out over the top of fist with one rope behind thumb

10. Take rope (rope 1) from behind thumb and wrap around it and over the next rope (rope 2)

11. Take second rope (rope 2) go over first rope (rope 1) and over next rope (rope 3) keeping first rope (rope 1) looped around thumb

12. Then take third rope (rope 3) go over second rope (rope 2) and over last rope (rope 4) again keeping first rope (rope 1) looped around thumb

13. Using last rope (rope 4) over third rope (rope 3) and thru loop of first rope (rope 1) that was looped around thumb

14. Tighten up each length of rope

15. Continue tightening ropes until a uniformly tight knot is created

repeat until six inches of finished length is reached or you have approximately 2” of rope remaining

17. Carefully insert pliers or hemostats thru finished knot using care not to disturb knot by going between sections of knot

18. Grab tail of rope with pliers or hemostats and pull tail thru existing kno

19. Trim excess from tail to 1/2” and warm with lighter

20. While still warm use end of lighter to press tail flush into knot

21. Repeat on remaining tails until all four are done and a finished 6” knotted length is created

22. Remove zip tie from completed section and from the next section of four ropes leaving one zip tie in place holding the remaining four lengths of rope in place

23. Using the four remaining ropes without the zip tie repeat to steps 9 thru 15

9. Spread the ropes out over the top of fist with one rope behind thumb

10. Take rope (rope 1) from behind thumb and wrap around it and over the next rope (rope 2)

11. Take second rope (rope 2) go over first rope (rope 1) and over next rope (rope 3) keeping first rope (rope 1) looped around thumb

12. Then take third rope (rope 3) go over second rope (rope 2) and over last rope (rope 4) again keeping first rope (rope 1) looped around thumb

13. Using last rope (rope 4) over third rope (rope 3) and thru loop of first rope (rope 1) that was looped around thumb

14. Tighten up each length of rope

15. Continue tightening ropes until a uniformly tight knot is created

repeat until six inches of finished length is reached or you have approximately 2” of rope remaining

24. Carefully insert pliers or hemostats thru finished knot using care not to disturb knot by going between sections of knot

25. Grab tail with pliers or hemostats and pull tail thru existing knot

26. Trim excess from tail to 1/2” and warm with lighter

27. While still warm use end of lighter to press tail flush into knot

28. Repeat on remaining tails until all four are done and a finished 6” knotted length is created

29. At this stage you should have 2 complete sections and four lengths of rope zip tied together

30. Remove zip tie from final four lengths of rope

31. Using the four remaining ropes without the zip tie repeat to steps 9 thru 15

9. Spread the ropes out over the top of fist with one rope behind thumb

10. Take rope (rope 1) from behind thumb and wrap around it and over the next rope (rope 2)

11. Take second rope (rope 2) go over first rope (rope 1) and over next rope (rope 3) keeping first rope (rope 1) looped around thumb

12. Then take third rope (rope 3) go over second rope (rope 2) and over last rope (rope 4) again keeping first rope (rope 1) looped around thumb

13. Using last rope (rope 4) over third rope (rope 3) and thru loop of first rope (rope 1) that was looped around thumb

14. Tighten up each length of rope

15. Continue tightening ropes until a uniformly tight knot is created

repeat until six inches of finished length is reached or you have approximately 2” of rope remaining

32. Carefully insert pliers or hemostats thru finished knot using care not to disturb knot by going between sections of knot

33. Grab tail with pliers or hemostats and pull tail thru existing knot

34. Trim excess from tail to 1/2” and warm with lighter

35. While still warm use end of lighter to press tail flush into knot

36. Repeat on remaining tails until all four are done and a finished 6” knotted length is created

37. Your new “Y” Shaped Dog Tug & Toss Toy should be complete and ready for your dog to enjoy