XW30K 8-1/2 Cm Shot Shifle

this is the one, the only, the shifle. in case you dont already know, the shifle is a pump- action shotgun/ rifle, with the ability to shoot 50 rounds in under a minute. this gun shoots about 30 feet, but shotguns arent usually used for long-range combat, but rather for close-range combat.

If you need help building some of the parts, you will find Ipod Killer's sniper here.

stats:

barrel style: ipod killer's drop-in type

magazine style: ipod killer's 5,11, or 50 (recomended) shot magazines

trigger system: backwards pull-release system (by ipod killer, but mine is backwards)

pump system: sliding wheel and pully system

ammunition type: yellow rods

handle type: ipod killer's sniper handle- shortened

slider type: one slot gray connector to gray rod slide

firing pin style: large rod -strengthened black- and blue extender connected withstring spindle.

1. make 24 of these
2. now put all 24 onto the gray rod like so
3. attach the string like this, leaving about 2 inches out

1. pull the string to the other side and wrap tightly around the rest of the gray rod a few times
2. place the string like this
3. this is the other side of the string placement in step 3
4. put the string trough this part of the connector
5. push a gray rod into it like this to hold the string in place
6. another pic of this
7. to finish, put another gray rod through the other side

this is exactly the same barrel as ipod killer's sniper rifle with one exeption-two pieces are taken away. refer to the pictures.

this is a pretty easy step to follow

hi

hi, me again

does this make enough sense?

this is the firing pin slider

simply make the trigger, by the way, there are 10 light blue washers

1. the back end of the gun that you will make next
2-6. steps progressing through the handle construction

construct the trigger

start the rear body

1. push the string through the front and under the wheels
2. when you push it through the front be sure top push it through the orange connecter
3. out the other side
4. over the top and through the orange connector again

self explanetory

pay attention to the gray connector in pic 3

connect like shown

1. the firing pin pushed all the way in
2. pull the firing pin out about this far before starting to wrap the string
3. wrap the string tightlyaround like shown
4. take the top part off and put the remaining part of the string into here
5. replace the rod back on like this

1. put on 2-4 thick rubber bands on
2. there should be about this much space in between the spacers and the end of the pin

i find that this is very easy to build according to the pictures

enter longer description for this step

1. this is ipod killer's 50 rod magazine, you can go to his sniper instructable to find out how to build the 5, 11, or 50 rod magazines, although i prefer the 50 rod magazine
2. the gun completed
3. the ammo

the safety mechanism
1. safety off
2. safety on

this step is just in case youre having trouble with the sring. the string should run down the middle of the gun, never on the outside. the purple is the string.

The string should be about 4 feet long.