Working Arc Reactor/fusion Reactor

in this instructible you will learn to build a real life safe fusion reactor that actually produces more energy than it intakes good luck. have fun!!

Supplies

2 air tight containers (preferably ceramic)

wire insulated and non insulated

thermoelectric generator or turbine system

high voltage transformers 6volts to 400,000 volts

1/4" tubing preferably pvp

drill

soldering iorn

hydrogen

bike pump valve

lead sheeting

barrel

Make the Container

Take one of the containers and drill a 1/5 an inch hole and insert pipe into it might need to use hot glue to seal it. next hot glue the bicycle pump valve onto the tubing. now drill two 1mm thick holes at the base of the container and push a piece of 5" uninsulated steel wire into each hole make Shure that at least one inch of wire is still sticking out of each hole. make Shure that it is airtight and pump in the hydrogen using the bike pump input. now wrap a 10' length of piping around the container leave a small length of piping still sticking out.now coat it it in one inch lead sheeting.

Set Up Electronics

set up the high voltage transformers in a vertical setup where the output of the first transformer goes into the input of the second transformer the output of the second transformer connect to the electrodes of the first container. !!!DO NOT TURNN YET!!!

Set Up Generator

for the thermoelectric generator use the leftover tubing that is sticking out of the first container insert it into the side wall of the second container by drilling 2 1/4" holes into the side of the second container and connect a coil of piping to it making a giant loop and then insert the generators on top of the coils and connect the wire(s) to lengths of 2' insulated wire that run out of the container. fill pipes with water

for the turbine option do everything the same except use turbines and do not make a coil instead connect the piping into the turbine. make a loop so there is a continuous flow of water .

Finishing Touches

on the output wires splice them so there are 2 output wires for each wire increase length using more wire and then connect one of each wire to the high voltage transformer series the other set of wires are the output wires.

You Are Done

good job you now have or own arc reactor like tony stark!!!!!