Bike Repair Stand on Work Bench.

by tony33770 in Workshop > Workbenches

32290 Views, 36 Favorites, 0 Comments

Bike Repair Stand on Work Bench.

Find a previous Instructable for (Mobile Bike Stand Repair.)
The upper section is used for bench application.

Drill Hole Into Wood Bench Top to Tightly Fit 1.5" PVC (use Additional Wood Blocking Below Top If Needed.)

Having a wood top helps - drilling hole into top will support this assembly

Clamp for Horiz. Bike Member Is From a "Tee"

Cut tee in half - hinge one side - use pull clamp to secure bike at other side - place filling (I used rubber sink mat) between bike tube & clamp. The grey PVC is Electrical conduit 90 deg.

Verify Bike Pedal Clearance

of all base items. El as shown should be ample (I used 11"-12" center to center of bike rail & base items.) If needed install a 1.5" PVC nipple extension befor tee.

Note Bungy Cord to Secure Front Wheel & Handle Bar.

I find stabilizing the front wheel makes working on the bike much easier.

This Is Original Mobile Repair Stand

note the call out for clamp & ell.

This Is Detail on Original Stand

Note details on fabrication of clamp & ell.