Wooden Wine Glass Rack

by RebeccaP107 in Workshop > Organizing

2145 Views, 26 Favorites, 0 Comments

Wooden Wine Glass Rack

unnamed (6).jpg

This is a simple bar to hold wine glasses. It sits nicely on any wine bottle and is a classy display.

Materials

pencil & ruler

1/4" poplar wood

sandpaper

curved file

drill press with 1 1/2" and 3/4" drill bits

band saw

Cut and Mark Wood

unnamed (1).jpg

Cut wood to approximately 12" x 2.5". Mark center and ends to drill holes. The end holes were drilled 1 1/4" from the edge.

Drill Center Hole

unnamed.jpg

Drill the center hole with a 1 1/2" bit.

Drill Side Holes

unnamed (3).jpg

Drill both side holes with a 3/4" bit.

Cut

unnamed (2).jpg

Using a band saw, make two cuts into each small circle to create a slit for the wine glass. The slit can be any length, as long as it is wider than the width of the stem of a wine glass.

Wood Burn

unnamed (4).jpg

Use a curved file to slightly round all the edges and use sandpaper to smooth the entire piece of wood. Using a wood burning pen, burn a design into the wood. A grape wine can be created by using three different tips on the pen.

Stain

unnamed (5).jpg

Stain the wood. I used Minwax Wood Finish: Gunstock 231. Follow the directions on the label.