Wooden Chair

This wooden chair is very easy to build and does not require power tools.

6 one and a half inch nails.

Five forty by four by one half inch birds.

Twenty , three inch screws.

A hammer.

A measuring tape.

A saw.

A screwdriver.

One six by one by 10 inch board.

Cut one of the 40 inch boards in half. (each one should be 20 inches)

Next you can figure out a way to balance the boards you just cut, along with two more 40 inch boards. (They should be about 10 inches apart.)

After that, cut the rest of the 40 inch board you had already cut from, and cut two ten inch long boards.

Take the two, forty inch boards, from step 3 and one of the 10 inch boards you just cut and screw it in place 10 inches from the bottom using 2 screws on each side.

Take the two boards you cut in half in the beginning and the other ten inch board, and use 4 nails to screw it in place 8 inches from the bottom.

Next, get another 10 inch board and cut it into 4, 10 inch pieces.

After cutting the forty inch board use 6 more screws to screw it onto the top part of the smaller section.(The section with the footrest.)

using another one of the ten inch boards, using 4 screws, screw it into the taller part 20 inches from the base.

Use the remaining 10 inch boards and screw them into both parts of the chair using 4 screws. (Do the same to the other side.)

Next get the last 40 inch board and cut a 10 inch piece off then nail it onto the middle base of the chair.

After that get the six by one by 10 inch long board and nail it between the two tall boards in the back.

Finally you can sand it or paint it if you want

That's it