Wine Racking Cane DIY
Homemade easy wine racking cane. Used to transfer wine from one vessel to another or bottling.
The Build and Materials
1/2 inch pvc pipe
1/2 inch pvc joint
1/2 inch pvc elbow
1/2 inch pvc cap
1/2 inch pvc to schedule 40 internal thread
5/8 inch nylon pipe nipple schedule 40 external thread
5/8 inch ID tubing.
or
(For bottling)
1/4 inch nylon pipe nipple schedule 40 external thread
1/4 inch nylon pipe nipple schedule 40 external thread
After assembly drill a few holes through the lower part of the cane just above the pvc cap. This allows the cane to suck up the wine and leave the trub behind.
!!! don't glue the pieces together!!!
This allows you to break the cane down to clean and sanitize all pieces.
1/2 inch pvc joint
1/2 inch pvc elbow
1/2 inch pvc cap
1/2 inch pvc to schedule 40 internal thread
5/8 inch nylon pipe nipple schedule 40 external thread
5/8 inch ID tubing.
or
(For bottling)
1/4 inch nylon pipe nipple schedule 40 external thread
1/4 inch nylon pipe nipple schedule 40 external thread
After assembly drill a few holes through the lower part of the cane just above the pvc cap. This allows the cane to suck up the wine and leave the trub behind.
!!! don't glue the pieces together!!!
This allows you to break the cane down to clean and sanitize all pieces.
Done!
This cane is 14 inches tall for a 5 gallon bucket. You can also make a longer section of the cane to us in carboys and 6 gallon bottling buckets.
let me know of any improvements I can make our different accessories I can add to it. Or perhaps other uses.
let me know of any improvements I can make our different accessories I can add to it. Or perhaps other uses.