Welder Storage Hook

by ALEX_HOLAND in Workshop > Organizing

1216 Views, 11 Favorites, 0 Comments

Welder Storage Hook

IMG_20160913_151149705.jpg

Ufff a lot of time since my last post.

Hope you lijke this small proyect.

Materials

IMG_20160913_142916716_HDR.jpg
IMG_20160913_143025853.jpg
IMG_20160913_143313123_HDR.jpg
IMG_20160913_143636183_HDR.jpg
IMG_20160913_144912650_HDR.jpg

Board 2cm Ithick, and plywood, 5mm thick

No measures, since it must fit your need.

Run through the table saw in order to get the same width

Rounded Corner to fit the cables.

The plywood mut be 4 inches longer than the board, and get the round corner aswell.

IMG_20160913_144500022.jpg
IMG_20160913_144608578.jpg
IMG_20160913_144916208_HDR.jpg
IMG_20160913_144623547.jpg
IMG_20160913_150822477_HDR.jpg
IMG_20160913_145339934_HDR.jpg
IMG_20160913_145448703_HDR.jpg
IMG_20160913_145354773.jpg
IMG_20160913_145440754_HDR.jpg
IMG_20160913_150653129_HDR.jpg
IMG_20160913_150942969.jpg

Cut the thin piece of board to length, and in angle, and fix it to the board whit glue and a screw.

Drill the holes for the screw to the hook and the ones to fix it to the the wall.

Find a paper clip, the bigger the better and drill thow holes for the screw. One bigger tjan the other, so the head of the screw can go through and attach it as its shown.

And we are done.

Fix it to the wall.

IMG_20160913_151104319.jpg
IMG_20160913_151131022.jpg
IMG_20160913_151149705.jpg

Profit !!!