Vacuum Clamp

simple print suction clamp that requires compressor or vacuum pump to run

This is a demo:

https://www.youtube.com/watch?v=eydZuZelm_g

Bill of materials:

1. M3 x 10mm (x8) for attaching the top
2. M3 x 22mm (x2) to attach the valve
3. Male Thread Quick Release Connectors Coupler 1/4" BSP (depends on your setup)
4. 6mm Tube to 1/4 BSPT Push Lock
5. 1/4 Turn 6mm Pipe Fitting Coupler Valve (I designed the holes for this specific
6. Air Compressor Hose Pipe (6mm OD)
7. PC6-01 Pneumatic Connector
8. Solid Foam Rubber Round at 8mm
9. Vacuum generator (if you are using a compressor)

Render animation:

https://www.youtube.com/watch?v=oPc6ZC5L1l8

The supplies are a bit different depending if you have a compressor or a vac pump.

These parts are for 3D printing. The Vac-body-01 requires support turned on. This fits on prusa MK3, MK4, Bambu Lap P1 and so on.

Connect with tubes according to diagram above.