V Tool for the Lathe
I made the tool from pallet and an old file .
Sorry if i don´t use the correct terms i do this for fun i hope you all enjoy !!!
Links to the:
What Do You Need
The awesome free palette wood and an old file
Get Your Wood Straight
Plane down the pallet wood straight so you can have a nice glue joint!
Glue and Clampsp
Make sure you use a nice amount of glue and a good amount of clamps so the wood won't split.
Cleaning the File
I used a grinder to clear all the file edges. Then used a water sand paper to sharpen all the edges.
Plaine Again
Plained the blank so it your be square again !
Cut!
I cutes 2 equal sizes to make a square blank for the handle
OMG PLAINE AGAIN !!!
Yap plaine both to the same thickenness !
Glue It "one Last Time"
I glue again . But with reverse so it would give a diferent look to the tool!
Cuting the Blank
I dicided how long i wanted the handle and cut it to size !
Turning
I turned the handle to a shape that i like and feel confortabale with !
A Piece of Pipe "yummi"
I cuted a piece o Inox steel pipe to use as a piece to prevent the wood from crackle when you add the tool tip !
Drill Drill a Hole
A hole to the tool tip . I tried to drill as straight as possible... a hole for the tip in the video did´nt loock that straight damit. the eye meter failed me !!!!
Note: normaly all my megurments are all by eyemeter.
Pipe
I added the pipe part, and glue with CA glue and a few taps with my mallet , and bam steel put in its place
Tool Tip
I did the same for the tool tip .Added CA glue hammer in with the malet and VOILA new Tool
The Happiness
The end
The happiness of having a beefy new tool from old Junk !!!!!