Uploading Sketch to Arduino Pro Mini Using Arduino UNO

I have started my way with the arduino UNO, moving to pro mini I didn't buy the USB adapter but used the UNO board to upload my sketches.

Very cerfuly remove the Atmel IC from the Arduino UNO, the pins are very gentel so be very cerful.
I used a flat driver, twisting it gently from both sides to take it out slowly bit by bit.

Connect UNO's pin 5v to mini's main VCC pin,
UNO's pin GND to mini's main GND,
UNO's pin RX to mini's RXI,
UNO's pin TX to mini's TX0,
UNO's RESET to mini's GRN

Load the sketch to the Arduino IDE, for the example I used the Blink sketch wich is also used for an Arduino first test

Set the IDE for using the pro mini board,

Tools => Board => Arduino Pro or Pro Mini (5V, 16Mhz) w/ Atmega 328

Upload the sketch using the regular uploading button.

You should recive the "Uploading Done" massage in the status bar and you are good to go, sketch uploaded.

Now go make something...