Upcycled Wood Card Holder

Hello, this was a quick project to use up some of my smaller off cuts of wood. Probably took about 2-3 hours. Enjoy

Wood: various small off cuts depending on what you want.
Super glue
Hacksaw
Drill
Sandpaper
Stanley knife

Play around with your off cuts to decide on size and where you want your gaps. I went with a mish mash to give me two heights and two full length rungs for letters. If you have a big block of wood or you only want a small holder then you may only want one or two pieces of wood. Mark out where to cut and cut your blocks.

I haven't got many photos here because I'm sure there's a better tool or way of doing this, probably on instructables. I marked my card rung then drilled a hole at either end a cut a ridge with a Stanley knife. Then I drilled a series of holes along the line as close as possible and used a combo of Stanley knife, pliers and drill to join the holes together. This was time consuming, not the kneatest and I also broke two drill bits so better ways of doing this welcome in the comments.

Everything needed a good sand down at this point. Then a few minutes to super glue things together and it's all done!
Would love to see pics if anyone makes one or has already made a similar project.