USB Kylo Ren Flash Drive

by benlsteawrt in Circuits > USB

439 Views, 0 Favorites, 0 Comments

USB Kylo Ren Flash Drive

This was a project I made because I had a extra flash drive and wondered what to do with it
I was thinking though my head what I got the idea to make a lightsaber
After I started I just kept on going and it turned out to be better than I thought it would be!!!!!

Supplies

Hot glue
Flash drive with status light
Aluminum foil
Black duct tape
Marker with lid
Small piece of red wire

Remove Plug From the Base of the Marker

You may need pliers

Pull the Marker Stick Out

Be careful not to ruin anything

Cut the Marker Right Past the “Z” in Crazy Art

Slide the Flash Drive in and Glue It Into Place

I used paper as filler

Cut a Piece of Hot Glue the Length of the Marker

Cut Two Nockes Into the Marker and Glue the Hot Glue in Place

Glue the Aluminum Foil Around As Shown

Add Aluminum to the Rest and Cut a Piece of Hot Glue the Length That You Want the Blade

Glue the Main Blade on and Use Hot Glue to Make Waves on the Blade and the Quillions

Use the Duct Tape to Make a Wrap Around It and Than the Cross Guards

Use the Duct Tape to Make Another Wrap Around the Top

Cut a Small Piece of Aluminum Foil and Glue It As Shown

Take a Piece of Red Wire and Glue It From the Piece of Aluminum Foil to the Bottom

Add some small pieces of aluminum foil to keep the wire in place

Cut a Gray or Black Marker Lid in Half and Cut Out the Inside Part

Cut Sections Out of the Marker Almost As Long As the Part of the Flash Drive That Plugs Into the Computer

Slide It on to the Drive, It Should Fit Tightly But Not to Tight

Take a Piece of Tape the Size As Shown

Wrap the Tape Around the Bottom As Shown

Finished!!!!!!!

Thank you for looking at this some ideas for use***
*put the Star Wars movies on it
*build all lightsabers and keep them on a shelf
*solder a led so it glows brighter than just the status light

Thanks for looking!!!!!!!!