Turnigy 9X 2.4GHz 8Ch Receiver (V2) PWM to PPM

Hello,

Do you build copter? Do you have Turnigy reciever with 8ch PWM? Do you need PPM?

I have a simple solution!

1) Turnigy 9x 2.4GHz 8Ch reciever (V2)

2) PPM Encoder Board

3) heat shring tube - diameter 19mm (37mm long)

4) solder

5) cutting spliers

6) tweezers

7) screwdriver

8) heat gun

First, I recommended you try if it works! Connect all channels as you can see in the picture.

PPM encoder pinout for sure:

INPUT:

1) GND - black

2) 5V - red

3) 1.pwm channel - white

4) 2.pwm channel - orange

5) 3.pwm channel - yellow

6) 4.pwm channel - green

7) 5.pwm channel - blue

8) 6.pwm channel - purple

9) 7.pwm channel - brown

10) 8.pwm channel - grey

OUTPUT:

1) GND - black

2) 5V - red

3) PPM - white

Disassemble the reciever. You unscrew the two small screws and carefully remove the cover. You can get out the PCB carefully from case. You can take back side (the antenna side) slightly up and pull PCB.

Now it is nessesary to remove the conectors (dupont). You can take a cutting pliers and cut wires how long is needed to placement to next side. Make them longer by 2-3mm , for sure.

Shave end of the wire around 2mm.

All the ends of wire solder tin little. Solder the wires as shown in piucture on the PCB very carefully!

Slide heat tube to PPM encoder and warm up for shrinkage.

Put reciever PCB with new PPM enc.PCB back to case as picture shown. OUTPUT must go first.

You must conect 3 pins to Flight controller -

red 5V (power for boths PCB)

black GND (power for boths PCB)

white PPM.

PWM pins on receiver will be empty! Power for receiver is taken from PPM encoder.

Now you can try it!

Good luck!