Trendy Ring From Bottle of Soap!

Equipment list required:

-detergent in plastic bottle

-models from which to take inspiration

-markers tempera and / or colored pasta (gutta)

-sheet of paper

-pencil and eraser

-glue or Uhu Pattex

-scissors

-sandpaper

-gloves

-lighter

Twitter: https://twitter.com/Creiamoin3D

Wash the Entire Bottle

Choose the bottle you want and with the special gloves wash it under running water.

Dry the bottle with a tissue.

With scissors, starting from the top, cut the bottle in half and dry well the inner parts.

Choose the model that you want to create and draw them on the sheet, possibly even color them.

Cropped accurately models created with marker and draw the contours on the bottle.

Cut out the whole piece, inside of which there are your forms and only later more precisely, the single piece.

With sandpaper try to finish the perimeter of your future rings; if you need to, you can use a lighter to "smooth" the edges.

Work, with colors or gutta to begin to give life to your ring.

Finish your work and let it dry completely.

Once dry your piece, you can proceed. Then you put the glue on the support that you will put in a card, so as to keep it and put the piece above!

Wait until completely dry out your new work and ... wear it!