Treat Feeder Dog Toy

This fun toy that is designed to stimulate a dog's mind and get a tasty treat.

• PVC saw/ wire saw
• Electric drill
  • ½” standard drill bit
  • 11/16” spade bit
• Drop cloths
• Measuring tape
• Pencils
• 1 ½”x90” PVC pipe
• 20: ½” PVC caps
• Sandpaper
• PVC primer and cement
• Goo Gone (optional)
• Dog Treats/Kibble

Measure and cut the PVC pipe into 10"-long pieces. You can use either the PVC saw or a wire saw to cut the pipe.

Sand the two ends of pipe.

Glue a cap onto each end of the pipe. First use primer, then cement, and put the cap onto the end.

Drill random holes that are about 1/2 - 1” in diameter. (I put the pipe into a table clamp to hold it still.) Sand the holes until they are smooth.

Use Goo Gone to clean off glue that slipped out of cap.

Put treats in PVC pipe and watch your dog enjoy rolling it around to get a nice treat.