Traffic Light LED

Originated from: https://www.makeuseof.com/tag/arduino-traffic-ligh...

The Arduino Traffic Light is a fast, easy, and fun project that could be done less than an hour.

Changes made:

- Button

The original project is that it would just keeping changing lights without a button. I changed it to if you press the button the LED lights will turn on.

- One button for 1 light

I installed 3 buttons, one for each color. Each button controls one color, so when you want to use a color you won't need to wait, instead you could just press the button.

Prepare the materials

-Breadboard x1

-Yellow x1, Green x1, Red x1 LEDs

- Connecting Wires

- Push buttons x3

- 220-ohm resistors x3

- 10k-ohm resistor x3

Connect the wires with the push buttons and LEDs.

1. Connect the anode of LED to pin numbers 8,9,10 then connect the cathodes to the board shown in photo #2 and #3

2. Connect the wires to the LEDs

3. Repeat the same same steps times

3. Connect wires to the button in order to control the LEDs shown in photo #3 and #4

4. Repeat the same step for two times so each LED gets a button

Connect and upload

The Code is the link below

https://create.arduino.cc/editor/chloesheu/a8f2e1b...

I used a box to decorate

https://youtu.be/brvvxEPYTKc.