TinkerCad Contest; Phone Holder

by scarerasacrow in Workshop > 3D Design

168 Views, 0 Favorites, 0 Comments

TinkerCad Contest; Phone Holder

2020-04-25 (9).png

Do you ever lose your phone, not have enough pockets for it. Or just wanna watch TV on it. Well now you can with this lesson.

Today I'm going to teach you how to make a phone holder for your arm, with an accessory to watch TV right off your arm.

Step 1: Start

2020-04-25.png

First take a cylinder and place at a 90 degree angle.

Step 2:

2020-04-25 (1).png
2020-04-25 (2).png

Next get a second cylinder that is slightly smaller than the first one. Next make it a hole and cut all the way through.

Step 3:

2020-04-25 (3).png

Next get a square, push it down until its only 13 tall.(Adjust to make your phone fit)

Step 4:

2020-04-25 (4).png

Next add the square and group them together.

Step 5:

2020-04-25 (5).png

Next get the same square then make it smaller, make it a hole but do not cut all the way through. (Adjust to make your phone fit)

Step 6

2020-04-25 (10).png

Next, get 2 cylinders and one smaller and the other larger. Make it a whole and cut all the way through to make way for the camera. (Adjust for your phone camera)

Step 7

2020-04-25 (6).png

Next, add a square and shrink down the sides until its 2 wide. Then make it a whole and place it in the middle, don't cut all the way through.

Step 8: Final

2020-04-25 (8).png

Make the same square and make the height 7 this will be the thing that holds your phone when watching on it.