The Production of Skateboards

the finished product is
finished as the three figures below

Select a box and parabolic in a basic shape,

Set the box to be 150 x w 30 x thick 2

The final copy is connected to the bottom
plate, and the finished product is finished as the three figures below）

and cut both sides of the
skate floor

Finally, as follows

Then the cut-out parabolic and the
square sides are docked and slightly uplifted by 7degrees, combined as follows）

Select the circular roof
shape to adjust to the following image shape after hollow, the skateboard bottom plate to modify, as shown below left, the final effect is as follows on the right

The front image below

Select a brick wall in the shape generator, resize and look at the figure

Select the spinner and adjust the spinner, adjust the spinner size, change the angle of the spinner, combine the following right picture

Adjust the height to 0.5 on the upper surface and on the surface on the base plate

Select snowflakes to resize and coincide with the base plate when the figure is positioned

Select curved words and text to enter text as follows

Finally as shown in the figure Finally as shown in the figure

Select the wheel and multi-point cylinder in the shape generator, select the cylinder in the base style, and adjust the shape style of the wheel as shown below

Adjust the wheel and multi-point cylinder and combine it as follows

After merge and copy,connect the results with a cylinder as shown below

Select a solderless connection and adjust the shape in the shape generator, select ios metric thread and cylindrical screws and form a connection device combined with the shape after adjustment with the unwelded connection

Connecting the combined connector to the axle, as shown below

The final copy is connected to the bottom plate, and the finished product is finished as the three figures below