The Extremely Easy and Fast Ductape Wallet!
by SoDDiggerCpl in Craft > Wallets
50994 Views, 50 Favorites, 0 Comments
The Extremely Easy and Fast Ductape Wallet!
This instructable will make a duct-tape wallet with almost no effort
Card Slots
Get some duct-tape, and cut off about two feet.
Now, take a credit card, and rap it with duct-tape so the sticky side faces out.
Repeat this step about four to five times.
Now, take a credit card, and rap it with duct-tape so the sticky side faces out.
Repeat this step about four to five times.
The Card-Wallet
Stick all of the card-slots together, make sure that they are all alligned equally.
Next, cut a piece of tape that is slightly wider than the bottom of the stuck-together card-slots.
Next, cut a piece of tape the length of the wallet, and stick the previously cut piece so it is under it.
Next, cut a piece of tape 1+1/2" longer than a card, wrap it around the card-slots so it wont stick to your pocket.
Your done with the slots.
Next, cut a piece of tape that is slightly wider than the bottom of the stuck-together card-slots.
Next, cut a piece of tape the length of the wallet, and stick the previously cut piece so it is under it.
Next, cut a piece of tape 1+1/2" longer than a card, wrap it around the card-slots so it wont stick to your pocket.
Your done with the slots.
The Money-Clip
Cut some pieces of tape the lengths of which should be:
4-1/8"
5-3/4"
11-3/4
2-1/2"
3/4"
Take the 2" and 3/4" pieces, and stick the 3/4" pieces 3/4" in from one end, and fold the other end down 1/2 an inch.
Take the 4-1/8" piece, and place it dead-center in the middle of the long piece, so it is flush at the top.
Next, fold the other half of the 4-1/8" piece over itself, and stick the 2" piece on the top of it.
Next, use the last piece to secure the pocket and cover to the main strip.
4-1/8"
5-3/4"
11-3/4
2-1/2"
3/4"
Take the 2" and 3/4" pieces, and stick the 3/4" pieces 3/4" in from one end, and fold the other end down 1/2 an inch.
Take the 4-1/8" piece, and place it dead-center in the middle of the long piece, so it is flush at the top.
Next, fold the other half of the 4-1/8" piece over itself, and stick the 2" piece on the top of it.
Next, use the last piece to secure the pocket and cover to the main strip.
Applying the Money-Clip
Take the money-clip piece, and wallet in hand. Hold the change-pocket to the middle of the wallet, and press the stick side(lacking the flap) and then press the other side to the back of the wallet.
Your wallet can hold up to twice as many cards as there are pockets, and up to 200 bills in the clip. To open the clip, grasp the flap, and pull it from the back of the wallet. put folded in half money on the front of the wallet, and fold+secure the money-clip over the money.
Your wallet can hold up to twice as many cards as there are pockets, and up to 200 bills in the clip. To open the clip, grasp the flap, and pull it from the back of the wallet. put folded in half money on the front of the wallet, and fold+secure the money-clip over the money.