Test Your Nerve!

Although extremely simple in appearance and construction "test your nerve" puts your manual skill to a lively test!

As shown in the photography a small loop is connected betwen the posts marked as "start" and "finish". The object is to guide the loop over the weaving course whitout touching the wire. A slight misjudment or quiver on the hand and loop will contact the wire. this sets off a loud "foul" signal from the buzzer and a light will on when the wire is touched.

The schematic above reveals a paralel arragement of circuit component, Whenever the loop touches the wire, the circuit is completed and the bulb-buzzer are energized, The power switch permits you to disable the circuit so the loop touches the wire may be hooked onto the wire.

There isn't critical in the arrangement or assembly of this basic game, start by cutting the wood to a proper dimenssion. it'd be a rectangle of (4x7) inch.

you'll need a posts of wood or steel (preffered) for a good conductive plate. the long is about 2''.

You can to use a N° 16 tinned cooper wire or similar is recommended betwen the two point

PARTS LIST

1 SW1 (OPTIONAL) SINGLE POLE SINGLE TROW TOGGLE SWITCH

1 BZ 9 V BUZZER

1 BATT 9 V BATTERIE

1 LAMP BULB 9.V FLASHLIGHT OR LESS

15'' x 14'' PIECE OF HARDBOARD

15'' No 16 TINNED COOPER WIRE

24'' No. 20 STRANDED HOOKKUP WIRE

1 BATTERY HOLDER

WOOD SCREWS

BRADS

As you can see the result is pretty good

You can add some stickers or any other thing thta you want to put in it!!!

Our parents and Granpa's are very nostagic cause this games was the the "hottest" in older older time.

We never forget the best!!!

Thanks!!