Super StratoVulcan Mark II

OrigamiAirEnforcer's Super StratoVulcan with a low speed wing, and a new aerofoil.
For Letter paper or A4.

Fold the paper in half lengthwise, and then fold a leaf from the bottom outside corner, to the top inside corner. Repeat on the other side.

Fold the bit that goes over the edge back in line with it. Fold the outside corner of this new triangle in, as in the picture. Open the halves.

Fold the tip down at the outside points of the diamond. Then fold the tip to the base, and then back up, about 2.5 cm down from the last fold.

This is hard to explain. You have to slide the edge of the wing outwards. Follow the Images and repeat on the other side.

Fold in half, and then fold down the canards, parallel to the keel. Then fold the wing tip down to the keel, and then fold this fold on to the keel.

Tape the fuselage shut, and make sure that you have a gull wing. (An M when viewed from the back. )Make sure that the leading edge droops. Fly and trim if needed.