Super Secret Case, for Small Things
by codz30 in Living > Hiding Places
4657 Views, 17 Favorites, 0 Comments
Super Secret Case, for Small Things
Ever needed a secret place to hold that, love note?, bullet?, coin? or anything similar?
Well, this is definitely what you need!
I mean, who ever checks the INSIDE of a lighter?!
Well, this is definitely what you need!
I mean, who ever checks the INSIDE of a lighter?!
Gathering Materials.
Well, as you have probably figured out, we are going to be hinding our valuables inside a lighter.
When doing this instructable, don't be afraid to modify the lighter to suit your own needs, after all, it is D.I.Y!
Materials:
Glue Gun, or any other type of glue, tarzan grip etc
Jet Lighter, like the one shown, a bigger lighter is preffered, look for ones with lights or similar, usually they are bulkier.
Screw Driver and Needle, to remove screws and hinges.
When doing this instructable, don't be afraid to modify the lighter to suit your own needs, after all, it is D.I.Y!
Materials:
Glue Gun, or any other type of glue, tarzan grip etc
Jet Lighter, like the one shown, a bigger lighter is preffered, look for ones with lights or similar, usually they are bulkier.
Screw Driver and Needle, to remove screws and hinges.
Pulling It Apart.
Ok, so you have your brilliant New York lighter (guess where it's from?!?.)
Step 1:
On the bottom of the lighter, next to the refill nozle, there should be a small screw, undo it.
Step 2:
Pull on the top of the cap, to remove the 'lighter' from the case.
Step 3:
Remove the gas canister, igniter, and any other assorted electronics.
To remove the 'dodgy' hinges if you have them, poke one side with a needle of pin, then slide the metal out.
Step 4:
Where the flame is produced, lift the ring off, using a screwdriver. Pull the gas feeder out.
Step 1:
On the bottom of the lighter, next to the refill nozle, there should be a small screw, undo it.
Step 2:
Pull on the top of the cap, to remove the 'lighter' from the case.
Step 3:
Remove the gas canister, igniter, and any other assorted electronics.
To remove the 'dodgy' hinges if you have them, poke one side with a needle of pin, then slide the metal out.
Step 4:
Where the flame is produced, lift the ring off, using a screwdriver. Pull the gas feeder out.
Putting It Back
Righto, so we have our lighter in bits,
Step 1:
Get the pushy down bit, and glue it back into its original position.
Step 2:
Slide the cap, back into position.
Step 3:
Put your super secret things inside.
If searched, you mearly present them with a lighter :)
Have fun!
Step 1:
Get the pushy down bit, and glue it back into its original position.
Step 2:
Slide the cap, back into position.
Step 3:
Put your super secret things inside.
If searched, you mearly present them with a lighter :)
Have fun!