Star Lord Helmet Out of Cardboard

I am making this for a fan of marvel movies and I hope you like it! 😁

1.Cardboard
2. scissors
3.a ruler
4.masking tape
5.sharpies (or any other felt tip pen)
6. clear plastic
7.paint (gold, black and silver/grey)
8. Paper

Measure with your hands from one eye to the other then hold your hand at a ruler to see how far it is. Mark the distance on the cardboard. Measure about 2 cm away from the marks and sketch the shape of the eye part on the helmet. Draw on circles for the eye holes. And cut it all out.

Measure from your forehead to the top of the eye piece you have already cut. Measure on the ruler. Mark the cardboard and sketch out the shape shown. Cut it out.

Do an out line of the two pieces so far. Draw a straight line down on both sides and sketch what is shown in the photo. Cut it out.

Draw around the part shown in the video. Draw a slanted line where shown. Mark where down and draw a line down. Cut it out and do it again.

Out line where shown. Draw lines where shown. Cut it out.
Out line where shown and sketch. Cut it out.

Draw and mark where shown and cut out.

Make two short paper tubes that are also quite wide and two smaller ones that are wide enough to put on a pencil. Use masking tape to tape the ends together. Cover the top and bottom with paper and tape. Glue the small tube to the big tube as shown.

Trace and draw lines as shown. Cut it out and repeat.
Measure around the back of your head and cut cardboard the same length.

Make six paper tubes that are quite thin and approximately 5cm long.

Get the clear plastic and cut it larger than the eye holes and use a pen to colour it red. Do that for both eyes. Tape the plastic over the eye holes.

Tape together as shown.

Paint the colours as shown.
Finished! I hope you liked this instructable!