Sponge Stamped Christmas Tree Card

by Penolopy Bulnick in Living > Christmas

6361 Views, 33 Favorites, 0 Comments

Sponge Stamped Christmas Tree Card

DSC_1122.JPG
I wanted to try stamping a fun little card for Christmas.  This is pretty simple and while an adult may need to cut the sponge, this is a great stamping project for kids!

Supplies

DSC_0991.JPG
DSC_0992.JPG
Time to get started!

Supplies:
  • Blank Greeting Card (and envelope)
  • Melamine Foam Sponge (I got mine at Daiso, it's a dense sponge, The Magic Eraser is made of it)
  • Green Ink Pad
  • Red Ink Pad
  • Yellow Ink Pad
  • Pencil
  • Optional: Brown and Black Marker
  • Exacto Knife or Scissors to cut the sponge
Get your Sponge Ready!  Using either a scissors or exacto knife, cut a corner from the sponge.  It doesn't have to be that big, mine is about an inch from flat surface to tip.  I like the cleaner cut of the exacto knife, but a scissors works too.  If you use an exacto knife, make sure to use a cutting mat.

Tree

DSC_1008.JPG
DSC_0993.JPG
DSC_0994.JPG
DSC_1005.JPG
DSC_1006.JPG
This is pretty basic.  Take your sponge, get ink on it and stamp it on the card.  When you push your sponge into the ink pad, try to cover all of the edge, the same for when you stamp it on the card.  If you just push from the middle, you are only going to get the center of the triangle.  

Overlap the bottom of one triangle with the top of another.  Stamp as many times as you want it tall.  I just went with four.

Decorate the Tree

DSC_1009.JPG
DSC_1010.JPG
DSC_1011.JPG
DSC_1012.JPG
DSC_1013.JPG
DSC_1014.JPG
Time to decorate your tree!  I just did red ornaments, but you can do whatever colors you would like.  Just stamp the eraser of your pencil in the ink and stamp it on your card.  Make sure you clean the eraser before switching colors and when you are done.  Don't want to get ink all over.

I added a yellow dot to the top of the tree to represent the star.  If you are talented, you can cut a start out of the foam.

Extras

DSC_1015.JPG
DSC_1016.JPG
DSC_1017.JPG
DSC_1018.JPG
DSC_1019.JPG
DSC_1020.JPG
DSC_1021.JPG
DSC_1022.JPG
Add anything else to the card that you need!  I drew in a simple stump for my tree, so it wasn't just hovering.  Then I just drew some lines around the edge with points.  These are my strings of lights!  I just stamped yellow or red at each point along the edge.

For an extra little something, something, use a smaller triangle and put a Christmas tree on the flap of the envelope.  Now you have a matching envelope and card set!  Now just fill in the card with your own message :)