Spiral Stepper Lift, a Knex Ball Machine Lift

Hello!

Here are the intructions for the fourth new lift in my knex ball machine Elysium.

It is based on the stepper lift, but instead of two sets of steppers, this lift has four.

In step 3, you can choose how high you want to make your spiral stepper lift.

The gearbox is different from the original one used in the ball machine, this one uses less gears.

When you encounter a problem or have a question, you can always send me a message. Thanks for watching / building!

~Sandroknexmaster~

If you want you can count the pieces before you start building.

Here is a list with all pieces included in this lift, named by their original colour:

RODS:

Green: 182

White: 143

Blue: 212

Yellow: 191

Red: 193

Grey: 1

Total rods: 922

CONNECTORS:

Dark-grey: 33

Light-grey: 17

Orange: 92

Red: 131

Green: 48

Yellow: 100

White: 54

Purple: 157

Blue: 47

Total connectors: 679

OTHER:

Blue spacer: 168

Silver spacer: 94

Tan clip: 11

Y-clip: 69

Small blue gear: 4

Medium red gear: 2

Big yellow gear: 2

Motor: 1

Total other: 351

Grand Total: 1952

This is the entrance where the balls wait to enter the lift.

You can choose how many steppers you want in your lift. I built 13 in this instruction, the same number I originally used in my ball machine. Keep in mind that you have to add three more steppers after this step. That means this lift will have a total of 16 steppers.

This is the exit. There is also one of the extra steppers in this step.

The second extra stepper for this lift.

The third and last extra stepper.

These parts connect the steppers to the axle.

The axle, where two sets of steppers are connected, twice.

The crank pushes the steppers up and down.

In this last step we will build the motor and attach it to the rest of the lift.

The Spiral Stepper Lift is finished!

Always slide the switch of the motor to the left.

Thanks for watching / building!

~Sandroknexmaster~