Spider.

Screen Shot 2013-10-22 at 2.34.49 PM.png

Screen Shot 2013-10-22 at 2.35.19 PM.png

Screen Shot 2013-10-22 at 2.37.39 PM.png

Screen Shot 2013-10-22 at 2.36.56 PM.png

Screen Shot 2013-10-22 at 2.36.23 PM.png

Screen Shot 2013-10-22 at 2.35.42 PM.png

Screen Shot 2013-10-22 at 2.36.39 PM.png

Screen Shot 2013-10-22 at 2.35.53 PM.png

Screen Shot 2013-10-22 at 2.37.53 PM.png

Screen Shot 2013-10-22 at 2.38.24 PM.png

I created this spider in 123D Tinkercad. This spider is mainly based off of a tarantula. I did my research on google images. I made this spider mainly for the "Make it Real-ly Scary with 123D and Tinkercad Contest" but I also made it to use as a decoration and to scare people. Before 3D printing I recommend scaling it due to me not scaling it to realistic size. When 3D printing I recommend using using black especially if you plan on using it to scare some one. some places I recommend placing it when planning to scare some one are behind a shower curtan or behind towels or in the silverware drawer.

Downloads

epic_snaget-habbi.stl

Legs.

Screen Shot 2013-10-22 at 7.17.51 PM.png

Screen Shot 2013-10-22 at 7.18.35 PM.png

Screen Shot 2013-10-22 at 7.18.54 PM.png

Screen Shot 2013-10-22 at 7.19.25 PM.png

Screen Shot 2013-10-22 at 7.33.15 PM.png

Screen Shot 2013-10-22 at 7.34.44 PM.png

Screen Shot 2013-10-22 at 7.34.53 PM.png

Screen Shot 2013-10-22 at 7.35.03 PM.png

Screen Shot 2013-10-22 at 7.38.50 PM.png

To create the legs I made a cylinder and than scaled it to size. After that I added spheres and grouped it (HINT: do not scale it after grouping with out holding shift or it will end out looking out something like the fourth picture. Now I put the segments on the proper angles and put them together. (do basically the same for the feelers)

Body.

Screen Shot 2013-10-22 at 7.47.05 PM.png

Screen Shot 2013-10-22 at 7.47.29 PM.png

Screen Shot 2013-10-22 at 7.49.07 PM.png

Screen Shot 2013-10-22 at 7.49.17 PM.png

To do the backside I put a half sphere and a paraboloid together. For the front I shrunk a sphere

Eyes.

Screen Shot 2013-10-22 at 7.53.01 PM.png

Screen Shot 2013-10-22 at 7.53.21 PM.png

Screen Shot 2013-10-22 at 7.55.39 PM.png

Screen Shot 2013-10-22 at 8.01.13 PM.png

Screen Shot 2013-10-22 at 8.02.23 PM.png

To do the eyes I first made a sphere and put it in a formation. Then I highlighted the eyes and scaled it smaller. I then made the hight equal. I then put the eyes at an angle.

Putting It All Together.

Screen Shot 2013-10-22 at 8.09.10 PM.png

The hardest part of putting it together is finding the right angles for the legs.