Sneaker Box

by Odin Chu in Living > Life Hacks

379 Views, 1 Favorites, 0 Comments

Sneaker Box

螢幕快照 2019-05-31 上午1.50.11.png
螢幕快照 2019-05-31 上午2.02.52.png
螢幕快照 2019-05-31 上午1.48.04.png

I made a sneaker box that can see the sneaker in the dark. I use LED bulbs and photoresistance. When the light is lower than the value that I set, the LED bulbs will turn on by itself. When the light is higher than the value the LED bulbs will turn off by itself.

Material

螢幕快照 2019-05-31 上午1.50.48.png
螢幕快照 2019-05-31 上午2.02.27.png
  • Transparent acrylic box
  • Resistor (1)
  • DuPont line (2)
  • LED bulbs (3)
  • Photoresistance (4)
  • paperboard or sneaker paper box

螢幕快照 2019-05-31 下午3.37.40.png

First, the photoresistance needs to connect to the A0 pin and connect to the positive and negative pin. There are two different kinds of resistors (step two). One is for LED bulbs and the blue one is for the photoresistance. You can use the DuPont line to increase the length of the LED bulbs. The pins connect the LED bulbs are 13 to 2.

螢幕快照 2019-05-31 上午1.50.26.png

ARDUINO code: https://create.arduino.cc/editor/Odin930405/c6d39bdd-10b9-44d2-ba56-afe3487fe9c1/preview

Step4: Dig Some Holes.

螢幕快照 2019-05-31 上午1.51.40.png
螢幕快照 2019-05-31 上午1.51.48.png
螢幕快照 2019-05-31 上午1.51.28.png

Dig some holes on the paperboard and let your LED bulbs through the board ( try to line up your LED bulbs). Use tape to sticky LED bulbs on the sneaker box and use tape to stick the board on the box.

Step5: Finish

螢幕快照 2019-05-31 上午1.52.52.png