Sliding Plate

It's a skateboard. It's got two colors and a special pattern. It looks good.

long13CM wide21CM

high1CM

*first place the paraboloid on the working plane and make it repeat.

*second expand the scale of repetition and lift it up, then change it into hole and original figure combination. （easy to make curved tips）

long55CM

wide21CM high1CM

*first place the cylinder on the working plane and repeat.

*second raise the repeating part and change it into the hole and the original figure.（a cylinder is easy to combine with a paraboloid）

*first combine the

corner and the middle part so that they are 81CM in length

*second trim with two rounded corners（to make the combination of two smoother）

*first, cut the slide in half with the cube

*second, copy and put them together

*finally, turn color（make the board more beautiful）

diameter5.5CM wide3CM

*First, cut the cylinder with two hemispheres

*second, combine it two rings and a cylinder

long7.5CM

wide5.5CM

*first, cut a cube with a cylindrical hole and combine it with a small cylinder（make the bracket more stable）

*second, one hemisphere is cut with a small hemisphere and transformed into a hole and bracket combination（make the shaft smoother）

*third, combine the assembly with two round edges and corners, a small cylinder and an arch（make bracket connection more natural）

*finally, cut two holes for decoration（beautiful）

Combine all part and add the pattern

Accomplish！