Slide and Lock Bracelet

I used ABOK 781 as the button knot for this project.

You can use this as a soft shackle/carabiner.

(Substitute for a light duty metal carabiner/shackle)

MiIddle your cord.

Bring both ends down to the point you want to place your knot.

.

NOTE: In each of the following steps the text and the left hand photo describe what is to be done.

The right hand photo shows the result.

Bring B over to right.

Bring B under and up through bight b.

Bring A under the loop.

Bring A over and through bight a.

Tighten the knot.

Bring A under B.

Bring A under bight a.

Turn the knot over.

Bring B under bight b.

Bring A under the two circled strands.

Turn the knot over.

Bring B under the two circled strands.

The knot is complete.

Tighten.

Take a separate piece of smaller cord and tie a simple overhand knot snugly around the loop. Leave a short tag end for easier grasping.

Trim off the ends (not shown).

Put the button through the loop and slide the locking knot to hold it in place