Skateboarding Introduction

by 993713202 in Outside > Skateboarding

249 Views, 0 Favorites, 0 Comments

Skateboarding Introduction

70FE9075332B64184F137DBC9049A09A.jpg

I am a novice

Put a Cuboid

图片1.png

At first, put a cuboid on the work plane,reduce its height and make a appropriate length and width.

I Put Another Coboid

图片2.png

Then,I put another coboid,which has the same height and length as the first one.Just press Alt(or Opt in Mac’s keyboard)to copy the same one.

Put a Coboid

图片3.png

After that,put a coboid that has the same size as the central one,just ruduce its length .Then copy it to have a same one.

As Shown in Figure

图片4.png
314FC2DF-4F05-42E6-9579-52A4C6CB5591.png

Put a cut cylinder,set its arc to 90,and set a same height as the board.Set cylinder’s radius same as the width of shorter cubiod.Put four cuboids that have the proper length and height to fit the cylinder,meanwhile,put the four around the board.As shown in figure:

​Place Text

图片5.png
图片6.png

Place text on the surface of the main board and input ZZULI,set a hollow form of the text.

Make Wheels

图片7.png
图片8.png

Make a slender cylinder as the connected part of the wheels,and put a coboid at both sides of the cylinder to make up one part.Then copy a same part.

Finally

398B46CE635C2AE32214E7A3247357E0.jpg

Finally,conbine all parts together,you can get a skate!