Single (para)Cord Heart Pendant

by hotmetalmel in Outside > Knots

87991 Views, 749 Favorites, 0 Comments

Single (para)Cord Heart Pendant

Step.jpg
Step 1.jpg
Step 24.jpg
Step 23.jpg
Step 22.jpg
Step 21.jpg
Step 20.jpg
Step 19.jpg
Step 18.jpg
Step 17.jpg
Step 16.jpg
Step 15.jpg
Step 13.jpg
Step 14.jpg
Step 12.jpg
Step 11.jpg
Step 10.jpg
Step 9.jpg
Step 8.jpg
Step 7.jpg
Step 6.jpg
Step 5.jpg
Step 4.jpg
Step 3.jpg
Step 2.jpg
Using a single piece of less than 3 ft of paracord you can make a heart shaped pendat necklace for Valentines day.

Step 1

Step 1.jpg
Fold the cord in half forming a bight.

Step 2

Step 2.jpg
Taking the right hand cord, make a counter-clockwise (CC) loop and lay the working end over the left cord parallel to each other.

Step 3

Step 3.jpg
Still working with the same cord, form another bight and tuck it behind the orig. left cord and through the CC loop from step 2.

Step 4

Step 4.jpg
Firm up the knot (which btw is ABoK #1133 labeled as a double noose... such a cruel irony for Valentine's Day) by pulling on each loop then taking out a bit of slack from the loose ends below. I placed a Qtr for scale. Pic should match yours so far.

Step 5

Step 5.jpg
Make another bight from the right hand cord and tuck around the back and through opposite loop on the left continuing through to the other side (going through both loops with the bight).

Step 6

Step 6.jpg
Make sure bight is through both loops.

Step 7

Step 7.jpg
Take up the slack.

Step 8

Step 8.jpg
Taking now the left cord, bight and tuck UNDER the first bight around and towards the back.....

Step 9

Step 9.jpg
..... Bringing the bight around and OVER the other cord/bight part.

Step 10

Step 10.jpg
To snug up the shape begin by pulling bottom right part (pictured at bottom of heart)

Step 11

Step 11.jpg
Phase 2 of taking up slack....

Step 12

Step 12.jpg
Turn peice over with the larger side of the heart now on the right.

Step 13

Step 13.jpg
And repeat steps 10 - 12 to tighten opposite side.

Step 14

Step 15.jpg
Like so.....

Step 15

Step 16.jpg
Pull both bights through like so, leaving the lines coming out horizontally.

Step 16

Step 17.jpg
Take left cord (coming from behind) and follow (above) the cord in front so both are coming out the right side.

Step 17

Step 18.jpg
Turn piece over so that both are now on the left

Step 18

Step 19.jpg
Taking the lower of the 2 cords repeat the same procedure as in steps 15 and 16. Cords should be horizontal as in pic of step 15 (only now with the double wrap inside).

Step 19

Step 20.jpg
Add a hitch to one side

Step 21

Step 21.jpg
Tighten.

Step 21

Step 22.jpg
Turn over and repeat same hitch.

Step 22

Step 24.jpg
Step 23.jpg
Add whichever bend you choose to close it. I like double fishermans knot because its adjustable but any knot will do. Last thing to do is give it to a loved one.