Simple Wrench Ring

Two ways to make a stylish ring from a wrench

Small combination wrenches (size ¼in or smaller)

Steel rods of differing sizes for different size fingers

Oxyasettling torch set with number 2 welding tip

Ballping hammer

Pliers

Vice grips

Welding gloves

Striker

Pedestal grinder with wire wheel

Use appropriate sizing rod and attach wrench with vice-grips; and pliers.

Light welding torch and heat wrench while using pliers to bend around steel rod until wrench is completely wrapped around the rod.

Attach wrench to steel rod with vice-grip and pliers. Then use pliers to bend wrench around steel rod.

Once wrench is shaped to desired size remove ring from steel rod with either pliers or ball-ping hammer. Run hot wrench under water then use pedestal grinder with wire ring to polish and buff the ring.

Once ring has been polished you can use sanding paper to polish hard to reach places.

When finished wear the ring and show off your love of tools :)