Simple Frequency Counter Using Arduino

In this tutorial we will learn how to make a simple Frequency Counter using Arduino.

Watch the video!

• OLED LCD Display
• Jumper wires
• Some sort of frequency generator, it can be another Arduino but in our case we will use a cheap 555 module.
• Arduino Uno or any other Arduino board
• Visuino software: Download here

• Connect 555 module pin[VCC] to Arduino pin[5V]
• Connect 555 module pin[GND] to Arduino pin[GND]
• Connect 555 module pin[OUT] to Arduino Interrupt pin[2]
• Connect OLED Display pin[VCC] to Arduino pin[5V]
• Connect OLED Display pin[GND] to Arduino pin[GND]
• Connect OLED Display pin[SDA] to Arduino pin[SDA]
• Connect OLED Display pin[SCL] to Arduino pin[SCL]
• Note if you are going to use some other source of frequency make sure that you connect (share) the GND with arduino GND.

The Visuino: https://www.visuino.eu also needs to be installed. Download Free version or register for a Free Trial.

Start Visuino as shown in the first picture Click on the "Tools" button on the Arduino component (Picture 1) in Visuino When the dialog appears, select "Arduino UNO" as shown on Picture 2

Add "Frequency Meter" component

Add "OLED" display component

Double click on the "DisplayOLED1"

• In the elements window drag "Draw Text" to the left side
• In the properties window set size to 2 and text to: Frequency
• In the elements window drag "Text" to the left side
• In the properties window set size to 2 and Y to 30
• Close the Elements window
  
• Connect "DisplayOLED1" pin I2C Out to Arduino board pin I2C In
• Connect Arduino digital pin [2] to "FrequencyMeter1" pin In
• Connect "FrequencyMeter1" pin Out to DisplayOLED1 > Text Field1 pin Clock
• Connect "FrequencyMeter1" pin Out to DisplayOLED1 > Text Field1 pin In

In Visuino, at the bottom click on the "Build" Tab, make sure the correct port is selected, then click on the "Compile/Build and Upload" button.

If you power the Arduino UNO module, the OLED Display will start to show the frequency in Hz that 555 module produces.

With 555 module you can adjust the frequency by rotating trimmers.

Congratulations! You have completed your project with Visuino. Also attached is the Visuino project, that I created for this Instructable, you can download it and open it in Visuino: https://www.visuino.eu