Silhouette Cameo 4 Crooked Cutting Repair
by theo_hexis in Craft > Digital Graphics
13682 Views, 13 Favorites, 0 Comments
Silhouette Cameo 4 Crooked Cutting Repair
When your cuts are not the way they should be probably there is a screw not tight enough inside the Cameo 4.
When you follow the next steps this issue should be over.
Good luck
Take Your Cameo 4 on a Flat Clean Suface.
Unscrewing
Turning the Cameo over and remove the 2 screws as shown on the picture.
Remove Cross Cutter
Remove the cutter unit and turn the Cameo back facing you.
Again 2 Screws
Remove the 2 screws as shown on this picture
Open Cover
Gently slide cover to the left side away from the Cameo
Screwing
When you look inside the machine from the backside you see a wheel which moves the under axel.
when you turn it you see 1 screw (See picture) Tighten this screw and reverse follow the steps and plug the machine back in.
Happy Crafting.