Serial Dew Point

Quick and easy dew point readings with XinaBox xChips and Arduino IDE.

Hardware components

• XinaBox SW01 x 1
• XinaBox CC01 x 1
• XinaBox IP01 x 1
• XinaBox XC10 x 1

Software apps and online services

• Arduino IDE

Introduction

I built this project using XinaBox xChips and Arduino IDE. It is a 5 min project , that allows you to read dew point data received from the xSW01 on the serial monitor. This project is an adaption of my previous Easy Peasy Temperature Monitor project. Using the xChips assembly is easy. The Arduino IDE software makes creating the code for the project simple.

• Go to Github.xinabox
• Download xCore ZIP
• Install it into Arduino IDE by going to "Sketch", "Include Library", then "Add .ZIP Library". As seen below.

Figure 1: Adding the ZIP libraries

• Download xSW01 ZIP
• Add the library the same way as you did for the xCore.

• Connect the IP01 and CC01 using an xBUS Connector. Make sure the xChips' names are orientated correctly.

Figure 2: Connected IP01 and CC01

• Insert into an available USB port.
• Download or copy and paste the code from the "CODE" heading into your Arduino IDE. Alternatively you could create your own code using the relevant principles to achieve the same objective.
• To ensure there are no errors compile the code.
• After successful compilation(no errors found) you may upload the code to your xChips. Ensure the switches are facing "A" and "DCE" respectively before uploading, if it is an IP01 with switches.

• Once the upload is successful, remove the IP01 from the USB port. Attach the SW01 with another xBUS Connector to the CC01.

Figure 3: Connected IP01, CC01 and SW01

• Insert the board back into the same USB port.
• Open the serial monitor in the top, right-hand corner of the screen. It should look like the image below after a few moments.

Figure 4: Serial monitor showing Dew Point readings

• You can now view dew point readings from the SW01 on the serial monitor.

DewPoint.ino Arduino
Arduino code for due point readings using the XinaBox xChips.

#include <xCore.h>  //add core library
#include <xSW01.h>  //add weather sensor library<br><br>xSW01 SW01;

const int DelayTime = 500; //Defining set delay time that could be used elsewhere in the code

//Create a variable to store the data read from SW01
float dew_point;

void setup(){

  //Initialise variables to zero
  dew_point = 0;

  //Start Serial Monitor
  Serial.begin(115200);

  //Start I2C communication
  Wire.begin();

  //Start SW01 Sensor
  SW01.begin();

  //String intro for project
  Serial.println("XinaBox Dew Point Experiment");
  Serial.println("____________________________");

  //Delay for sensor to normalise
  delay(3000);


}

void loop(){

  //Read and calculate data from SW01
  SW01.poll();

  //Request to get humidity, temperature and dew point data then store in the variables
  dew_point = SW01.getDewPoint();


  //Display recorded data over the Serial Monitor

  Serial.print("Dew Point:");
  Serial.print(dew_point);
  Serial.println("℃ ");

  delay(5000);

}