Screw Knight Statue

The list of supplies you need for this project are:

2 M8 x 45 mm screws

4 M6 x 35 mm screws

2 M4 x 35 mm screws

2 M5 x 35 mm screws

1 M8 x 20 mm screw

4-5 hot glue sticks and 1 hot glue gun

1 flat board of wood around a 8in x 5in area

1 spoon

1 small screwdriver

First grab your 8in x 5in wooden board and lay it out with the 5 inch side facing you

Then grab 2 M5 x 35 mm screws and hot glue them at an angle so it looks like the figure will be in a fighting stance. You should hot glue the screws so the screw head is facing up where the knee joint will be.

Finally grab 2 M6 x 3 mm screws and hot glue the screw heads to the screw heads of the first 2 screws to form the knee joint of the figure. The end of the screws should be close to each other so you can hot glue them together to form hips.

Grab your 2 M8 x 45 mm screws and hot glue them together at the end of the screw so the screw heads are at opposite ends of the piece.

Then hot glue one of the screw head ends to the ends of the leg pieces. This will form the "hip" joint of the figure.

Next grab the last 2 M6 x 35 mm screws to form the biceps of the figure. Hot glue the screw heads a little bit below the screw head of the M8 x 45 mm screw. This will create the shoulders of the figure.

Take 2 M5 x 35 mm screws and glue the screw heads to the back of the shoulder screws. then connect the other end to the back of the body screws. This will fill out the figure so its not as thin and seems more human like.

Now grab 2 M4 x 35 screws and glue them to the end of the M6 screws. The screw heads of the M4 screws will form the "hands" of the arms.

Grab 1 metal spoon. Begin bending the handle back and forth to create heat and allow you snap the handle off.

Then create a wrap around of the spoon so it will stick to the hand/screw head. When first making the shield connection the shield fell off so I had to add extra support for it to stick together.

Finally take your small screwdriver and glue it to the hand. Make sure the long side of the screwdriver is facing up so that it looks like a sword

Grab the last screw, a M8 x 20mm screw and hot glue it sideways so the screwhead is the face of the head.

Now you are finished!