Sandal and Shoe Support Strap

Sewing Machine

Leather Sewing Machine Needles

Leather Glide Presser Foot

Cotton

Eyelet Tool

Scissors and Rotary Cutter

Tape Measure

Sewing Ruler

Mini Clothes Pegs or Sewing Fabric Clips

Leather Pieces (to match shoe and foot measurements)

Shoe Buckles and Rings

Cotton Twill

While wearing your choice of shoe, use the tape measure to measure the width around from under the foot (arch to top of the foot), and around the ankle(outer ankle to inner ankle, from back of foot and over front of ankle). Ensuring that you can fit one finger between the foot and tape measure. This will apply to the strap as well.

Cut strips of leather according to measurements, allowing excess for the buckle and ring. Cut buckle pieces of 5cm each. With eyelet tool's smallest punch, make small holes in center of buckle piece for buckle pin to fit through (as shown in 4th picture).

Sew cotton twill onto "wrong side" of leather straps.

Sew both the underfoot strap as well as the ankle to ankle (back) strap through the rings (x 2 rings for each strap). Then sew "over foot" strap onto inner ring, ensuring to "mirror" for other strap. ENSURE THE BLACK TWILL IS ON THE INSIDE.

Sew the buckle onto a smaller piece of leather, then attach to the outer ring, for each shoe strap. I chose to hand sew the buckle on, as it was a bit of a tight fit for the sewing machine.

Using smallest punch of the eyelet tool, make eyelets in the "over foot" part of the strap.

Fit strap over shoe, ensure that you can fit one finger under the strap when buckled. These straps can be worn with any heeled shoe or sandal, except for wedges or platforms.