Rustic Wooden Roof Racks

by EllisB11 in Workshop > Cars

530 Views, 0 Favorites, 0 Comments

Rustic Wooden Roof Racks

20180814_161325[1].jpg

Were going to be drilling hols through the roof a Toyota echo (echo echo echo) sticking bolts through and slapping some wood on there.

My friends parents used to put wooden roof racks on all there cars to move there canoes around they would nail old carpet to them to for a better contact surface on the boats.

As for the "structural integrity" of these racks you get what you pay for, I spent about 14 Canadian dollars.



What You Are Going to Want

20180814_152116.jpg


Wood this will be different depending on your cars size and what you want, I used a pallet because its cheep and already cut to the right size for me.
2 four ft long 2x4s
8 little spacer blocks

A Drill with a metal bit I used a 1/2 inch bit

Ratchet set and Wrench (or two wrenches)

4 long bolts, I used 6 inch long 1/2 inch bolts and two 5 inch bolts because that's what I had, you will probably want to user 4 of the same size.

4 nuts.

8 large washers, mine are about 3 inches wide

A tube of caulking or some kind of water proof sealant

Measuring tape and marker (if your into that kind of thing)

Something flat to get the roof carpet off

Move Your Roof Carpet Out of the Way

20180814_161745.jpg
20180814_161753_HDR.jpg
20180814_161740_HDR.jpg
20180814_161535.jpg

My roof carpet is held in with these little tool less plastic clips, then just tucked into the plastic around the windows, so I was able to pop the clips out and roll the carpet forward. If your not lucky enough to drive an echo (echo echo echo) this might be a lot harder and you might decide that you just don't care and want to cut. My friends parents would never put the carpet back in.

Drill Your Holes

20180814_151736.jpg
20180814_151803.jpg
20180814_153310.jpg

Measure where you wand your holes (or like whatever) then drill baby drill!

Drill Your Wood

Were going to want to line up the holes in your wood with the holes in your car I recommend a measuring tape for this (or like whatever)

Seal Your Hole Unless You Think Rain Is a Conspiracy Theory

20180814_153509.jpg

Calk the inside and the outside of your hole

Slip a washer on the inside then slide a bolt through

Slid Your Pre Drilled Wood Onto the Bolts

20180824_002348[1].jpg

With a wrench on the bolt inside inside your car use a ratchet or wrench to tighten the nuts on the outside.

Put Your Roof Carpet Back On

20180824_002401[1].jpg

Done!
Now spray paint your hubcaps gold and wait for all the accolades and notes from your small town

neighbors to roll in.