Rolling Coin Sorter

I made this easy and cool sorter for coins for a school project. It is very easy to 3d print and works with United States coins( Quarter, Dime, Nickel, and penny). I go to the Cold spring harbor high school in long island NY.

I thought this would be a fun way for me to store all of my extra coins and have them sorted out for when I need to use them.

You will need a 3d printer and a computer with fusion 360.

Open up fusion 360 and make a 12 inch by 12 inch sketch.

Use the extrude tool to extrude the base upwards by 4 inches.

Use the square sketch tool to make 4 rectangles and use the offset tool to make 0.2 inch borders.

Use the extrude tool to make four -3.5 inch deep holes.

On top of the storage base create a 2 inch by 20 inch rectangle.

Use the extrude tool to make the rectangle 4 inches tall the use the chamfer feature as much as you can on the short side.

Draw 2 lines and use the offset feature to make 0.6 inch walls.

use the extrude tool to extrude your sketch down by 3 inches.

Use the sketch tool to make holes over the coin storage. fit it to the coins you use in your country from smallest (top) to largest (bottom). And you're all done making your very own coin sorter! I hoped you enjoyed this project and had fun making it.